Barnes Plumbing Solutions catalogue
Review the applicable model family, document revision and selected configuration with your quotation.

Barnes 3SE family image from the manufacturer. Confirm the exact 3SE2054L configuration with your quotation.
Submersible sewage ejector for building wastewater systems, selected to suit the pit and discharge duty. Contact HTS for pump repair, replacement and installation in Toronto & GTA.
Pump Service & Installation Quotes For Toronto & GTA Buildings.
Send the full nameplate and installation photos. Current supply, pricing and installation timing are confirmed in your quotation.
Choose a model to ask HTS about your building.
The referenced Crane/Barnes 3SE-L technical data identifies this model as part 132756. Confirm the installed nameplate, current configuration and operating duty before ordering.
| Model / Series | What To Confirm |
|---|---|
| 3SE2054L Part 132756 | 2 hp; 575 V, 3 phase, 60 Hz; 1750 rpm; single seal; 3-inch NPT discharge. |
HTS can help identify the equipment and plan the required work. A site assessment may be needed to diagnose faults or confirm the replacement selection and installation scope.
Explore Pump Repair & MaintenanceManufacturer literature and an HTS review of the proposed pump and installation scope.
Review the applicable model family, document revision and selected configuration with your quotation.
Barnes
SP33 / SP50 / SP75 sump pumps
Groundwater and dirty-water sump duty with limited solids; building drainage locations where the verified pump curve and pit conditions fit.
Barnes
2SEV / 3SE / 3SEV sewage ejector pumps
Sewage and wastewater lift from building pits; series differ in impeller, discharge and solids capability.
Sulzer
ABS AS 0530–0841 wastewater pumps
Building wastewater, sewage and underground-garage drainage, subject to hydraulic and solids selection.
For a Barnes 3SE2054L that trips, fails to start or cannot clear the pit, contact HTS with the fault symptoms and nameplate photos. We can help plan pump service or a replacement installation, including the existing controls and discharge connection. Send the full equipment details and required work to begin.
The full model number is a starting point. We also need the required flow and pressure, electrical supply, materials, controls and installation details. A matching horsepower or a similar family name does not establish an equivalent replacement.
Send your pump model and building details. We’ll help you arrange service or plan a replacement.